AutoCAD 2013 SP1.1

No posts all month and then two within a half an hour.  Go figure.

But I just became aware that Autodesk re-released updates today for the packages that failed a few weeks ago immediately after they were posted.  32-bit and 64-bit versions of the new Service Packs can be found here:

AutoCAD 2013 Service Pack 1.1
AutoCAD LT 2013 Service Pack 1.1

A couple of things to note about these:

1. They are for AutoCAD only and will not work on any of the vertical products.  Separate SP's for vertical products will be created and issued as appropriate. 
2. Also, if you previously applied the original SP1 before it got pulled you can simply install SP1.1 right on top of it.

As always, be sure to go thru the ReadMe file that accompanies any update very carefully and follow all the directions.

I'll be watching the boards closely over the next few days to see how the user community is reacting to this repair package.  If the feedback looks positive I may take a dive back into 2013 waters myself.  We'll see.